Linux Forums - Linux Help,Advice & support community:LinuxSolved.com
Others => Miscellaneous => Topic started by: piyush on September 24, 2004, 09:40:40 AM
-
Hello,
my red hat 9 system configured for a GUI based login at startup, gives command prompt login which keeps on blinking and does not allow to login, it was running fine till a day back. i dont know what caused the problem suddenly. please help as soon as u can, because i have to run it fast...please advice anything except reinstallation.
Regards,
Piyush.
-
Hi,
Try this.Boot in single user mode(if using grub select the Linux entry and hit 'e'. Select the kernel.... line and hit e again for editing.Then at the end of the line append a 'single' .Then hit enter and press 'b' to boot.The system should boot into single user mode.)
Now at the shell prompt change the runlevel from 5 to 3 using vi on /etc/inittab.You could also type 'telinit 3' to be immedately switched to runlevel 3.There you can use 'startx' to start gui mode or to troubleshoot if X crashes or sth.
-
just check whether id:5:initdefault: line is like this.... then restart you X server....
-
How? His console's not logging him in!
-
I encounter a similiar problem just yesterday. After flashing couple of times, the X configurator will show up. Just denied/ Cancel all the way till the end, you'll get to login through the console.