Linux Forums - Linux Help,Advice & support community:LinuxSolved.com
Linux Software => Linux Installation Support => Topic started by: admore on April 02, 2005, 11:28:54 AM
-
:( well, l am tryingto install REDHAT9 on a Gateway2000 ( which has a Window$ 98 running, but l intent ot format the drive during linux installation), with 2G HDD, and 64MB RAM. l pop in the CD and boot. Then the screen says linux <enter>and linux text <enter>, there is nor red hat ( in red) as the normal installation. Pressing F2 up to F$ shows the screens fine. When l hit enter, the screen goes blank forever, but l can hear the sound of the CD activity.
What is happening, and what is the way around this. Is the issue a video driver or what?
:shock: Admore
-
your compuer seems to be having very limited in resources..
Instead give a try to Smoothwall !
-
your compuer seems to be having very limited in resources..
Instead give a try to Smoothwall !
Does it mean that is why( low resources) the machine presents the black screen???
What are the minimum resources required for RedHat9 installation??
Help, l want this to be a Webserver with MySQL...
I cannot afford another machine!!!! ( sob)
-
I had tried to install RH9 on pc with configuration equals to yours but atm processor was fast enough . It was P4 1.5 Ghz .
But still i was not able to install, then I Installed RH7.2 in text mode.
RH9 needs a good processor.. basically ghz one and min. 96 mb of RAm but practically 256 should be considered minimum. Hardisk is also very low in space for u!
I have suggested smoothwall, which is meant specially for gateway but not webservers.. still you can install apache, php , mysql etc on it.'
If you can increase RAm to 256 mb the you can do.. but still later hd will become a barrier.
Alternatively.. Install an old LINUX distro which as low system requirements.
-
hi ..
Can u tell what VGA card do u have..??
It may be a pb of low resources & may be of VGA card.. as the above memory is also in 1 of my computer but still its running....
Gaurav
-
well, l connot boot into my Window$, after l changed some monitor settings. The only information l can get from looking at the hardware and boot infor is that it is an onborad VGA card, PCI bridge VGA.
How can l probe for more information??
-
well, l connot boot into my Window$, after l changed some monitor settings. The only information l can get from looking at the hardware and boot infor is that it is an onborad VGA card, PCI bridge VGA.
How can l probe for more information??
Please add to the above information: l cannot get the installation to run ( l still get the black screen) even if l try to use "linux text". l ma using a Likom monitor ( fairly new) and the old box.
Thank you