Linux Forums - Linux Help,Advice & support community:LinuxSolved.com
Network Troublshooting => General Networking Support in Linux => Topic started by: FNC on December 25, 2006, 01:35:38 PM
-
Hello every one.
well i am a newbie to linux and i am searching for your help, i will walk through step by step.
first of all i have installed RHEL 4 AS
i want to conect it to the internet, i have uplink through a local isp on ether0 and my downlink is through a pent@net dvb card which is fully routed though my local isp, so only have to insert the ip addresses.
can u help me how to configure pent@ on RHEL and make the internet work.
thanks
-
I don't have experience about DVB cards, may be you can elaborate a little so that I can guide you.
Other part is so simple, only I don't have information about dvb cards.
-
thanks ricky for your reply. ok i will try to investigate and do a tests to see if it works with me or not.
after this part i want to know if your squid configuration works , or it needs to haver some tweaks to work using rhel4 as and the dvb card
]thanks again
-
Squid thing shall work in RHEL.