March 28, 2024, 08:02:12 PM

News : LinuxSolved.com Linux Help Community Forum..


Author Topic: modem detection and installation  (Read 5568 times)

Offline vicky

  • New Member
  • Posts: 3
modem detection and installation
« on: May 27, 2004, 09:35:21 AM »
I have installed red hat 9. Have an internal Dlink 560IS+ modem with SM56 Motorola Chipset. Help needed for detedtion and installing..

My output for ->   cat /proc/pci   is below...

PCI devices found:
  Bus  0, device   0, function  0:
    Host bridge: Intel Corp. 82815 815 Chipset Host Bridge and Memory Controller Hub (rev 2).
  Bus  0, device   2, function  0:
    VGA compatible controller: Intel Corp. 82815 CGC [Chipset Graphics Controller] (rev 2).
      IRQ 11.
      Prefetchable 32 bit memory at 0xe0000000 [0xe3ffffff].
      Non-prefetchable 32 bit memory at 0xe4100000 [0xe417ffff].
  Bus  0, device  30, function  0:
    PCI bridge: Intel Corp. 82801AA PCI Bridge (rev 2).
      Master Capable.  No bursts.  Min Gnt=6.
  Bus  0, device  31, function  0:
    ISA bridge: Intel Corp. 82801AA ISA Bridge (LPC) (rev 2).
  Bus  0, device  31, function  1:
    IDE interface: Intel Corp. 82801AA IDE (rev 2).
      I/O at 0xf000 [0xf00f].
  Bus  0, device  31, function  2:
    USB Controller: Intel Corp. 82801AA USB (rev 2).
      IRQ 11.
      I/O at 0xd000 [0xd01f].
  Bus  0, device  31, function  3:
    SMBus: Intel Corp. 82801AA SMBus (rev 2).
      IRQ 5.
      I/O at 0x5000 [0x500f].
  Bus  0, device  31, function  5:
    Multimedia audio controller: Intel Corp. 82801AA AC'97 Audio (rev 2).
      IRQ 5.
      I/O at 0xd400 [0xd4ff].
      I/O at 0xd800 [0xd83f].
  Bus  1, device   2, function  0:
    Communication controller: Analog Devices SM56 PCI modem (rev 0).
      IRQ 9.
      Master Capable.  Latency=32.  Min Gnt=1.Max Lat=255.
      Prefetchable 32 bit memory at 0xe4000000 [0xe40000ff].

Offline Ricky

  • LST CareTaker
  • Specially Skilled
  • *****
  • Posts: 2381
modem detection and installation
« Reply #1 on: May 27, 2004, 12:30:10 PM »
first of all you give output of the following command here :)
Code: [Select]
cat /proc/pci